For Int'l Orders Call +001 800 242 3477
Cart 0
See Table below for product specifications.
IMI PowerLift® Lifting Magnets, Capacity - Flat Surfaces 180-6600 Lbs, Round Surfaces 125-3300 Lbs - WiscoLift, Inc.

Industrial Magnetics

IMI PowerLift® Lifting Magnets, Capacity - Flat Surfaces 180-6600 Lbs, Round Surfaces 125-3300 Lbs

$ 315.00

When you need powerful lifting magnets that are compact, Rare Earth Magnets can be used on flat or round surfaces and contain an internal release On/Off device that does not contact or damage the surface of the part being lifted. Permanent magnetic lifts eliminate the fear of dropping the load being lifted due to power failures.


The new handle on the PowerLift® Rare Earth lift magnet features a positive lock-on and lock-off mechanism that requires the operator to manually switch between the two states. This prevents the handle from being turned only ”partially on” and giving the operator a false sense of security that the magnet is holding safely, or from being accidentally bumped to the “off” position, dropping the load pre-maturely.
Features:
  • ON/OFF Rare Earth design
  • Lifts flat or round loads
  • Easy internal manual release does not contact the load
  • Heat resistant up to 180°F (82°C)
  • Conforms to ASME B30.20

NOTE: Lifting Values for the PowerLift® Magnets are stated at 33% of the actual value. We recommend when lifting sheets over 8', use 2 or more lifts on a spreader bar to prevent sheet flexing, sagging or peel-off. Thin material is susceptible to magnetic bleed through, resulting in two sheets being lifted at once. Round Lifting Values are based on ideal conditions. Consult the factory before specifying these magnets for use on round materials. *Max. sheet lengths are selected due to sag characteristics of specified sheet. The item to be lifted must cover the entire length and width of the magnetic poles to properly engage and release the part. CF = Consult Factory, NA = Not Applicable (Magnets will not turn "ON" with stated thicknesses.)
WARNING: Never stand under load being lifted. Always use extra caution. Only use magnetic lifts on material that does not flex or bend. The surface of the lift, and the load being lifted, need to be clean and free of chips, oil, slag, dirt, etc. Lifting magnets must be centered on load. Not recommended for painted or finish coated surfaces.
A 6600 Lb. capacity magnet is also available and quoted per application. There is a 16-18 week lead time for shipment. For more information on lift magnets, please call our Sales Representative at 800-242-3477 or email us at csr@wiscolift.com.

Share this Product


More from this category